priority 0 member is a member that
cannot become primary and cannot trigger
elections. Priority 0 members can acknowledge write
operations issued with write concern of
w : <number>. For
"majority" write concern, the priority 0
member must also be a voting member (i.e.
0) to acknowledge the write. Non-voting replica set
0) cannot contribute to
acknowledging write operations with
"majority" write concern.
Other than the aforementioned restrictions, secondaries that have
priority 0 function as normal
secondaries: they maintain a copy of the data set, accept read
operations, and vote in elections.
Configuring a replica set member with
priority 0 might be desired if the
particular member is deployed in a data center that is distant from
the main deployment and therefore has higher latency. It may serve local
read requests well, but might not be an ideal candidate to perform the
duties of a primary due to its latency.
For this situation, the following diagram shows a data center on the left which hosts the primary and a secondary, and a data center on the right which hosts a secondary that has been configured to have priority 0 to prevent it from becoming primary. Because of this setting, only the members in the left data center are eligible to become primary in an election.
Compare this to the default priority for replica set members,
priority 1, where either of the
secondaries in this scenario would be eligible to serve as primary. See
Replica Sets Distributed Across Two or More Data Centers for
A secondary with
priority 0 can
function as a standby. In some replica sets, it might not be possible
to add a new member in a reasonable amount of time. A standby member
keeps a current copy of the data to be able to replace an unavailable
In many cases, you need not set standby to priority 0. However, in replica sets with varied hardware or geographic distribution, a priority 0 standby ensures that only certain members become primary.
A priority 0 standby may also be valuable for some members of a set with different hardware or workload profiles. In these cases, deploy a member with priority 0 so it can't become primary. Also consider using an hidden member for this purpose.
If your set already has seven voting members, also configure the member as non-voting.
When configuring a secondary to have
priority 0, consider potential failover patterns, including
all possible network partitions. Always ensure that your main data
center contains both a quorum of voting members and members that are
eligible to be primary.