Hi,
I am using an apikey to show the status of a cluster in Atlas which i have paused.
The status is IDLE . Is it the correct one?
Hi,
I am using an apikey to show the status of a cluster in Atlas which i have paused.
The status is IDLE . Is it the correct one?
Hi @Mugurel_Frumuselu , could you share which command did you use to pause the cluster?
If you used atlas clusters pause dba-test2
then it’s the right STATE
you see. To double check, you can try running the command again. If the cluster is already paused you’ll receive an error message informing you about it.
@Jakub_Lazinski Regardless if the cluster is paused or not the status show “IDLE” in both cases.
Is that intended?